Toyota Funcargo NCP20 Not Shift in Fourth

1999 Toyota Funcargo NCP20 Engine Model 1NZ-FE

Situation
The car couldn't be put the gear in fourth.

Cause
Faulty oil temperature sensor.

Maintenance
Diagnosis noticed cord38 P0710 that meant oil temperature system.
Then I took off it and checked resistance.
There was disconnecting of wire.
I changed new oil temperature sensor.

Toyota Ipsum SXM10G A/C Compressor OFF

1997 Toyota Ipsum SXM10G Engine Model 3S-FE

Situation
After turning on A/C switch, A/C indicator lamp blinked and turning off A/C compressor.

Cause
Faulty A/C compressor lock sensor

Maintenance
When I checked the A/C compressor lock switch, I found that the sensor had been breaking of wire.
Then I rapaired it to soler .
It worked properly.

Toyota Mark2 GX100 E/G Hesitate

1998 Toyota Mark2 GX100 Engine Model 1G-FE VVT

Situation
Engine hesitated on acceleration and idled erratically.

Cause
Faulty OCV

Maintenance
Diagnosis noticed P1349 that meant VVT system.
This car did not change E/G oil oftenly.
There were excessive carbon built-up in the OCV.
Then I changed OCV and VVT assembly.

Toyota Rav4 SXA10G Radiator Fan Rotate At IG ON

1994 Toyota Rav4 SXA10G Engine Model 3S-FE

Situation
Radiator fan and condenser fan rotated at IG switch on.

Cause
Faulty Coolant temperature sensor.

Maintenance
At first I looked into wiring diagram.
Then I judged that coolant temperature sensor or pressure switch had had problem.
The pressure switch was properly.
I checked the coolant temperature sensor .
It was faulty. Then I changed new coolant temperature sensor.

Toyota Premio ZZT240 A/C Lamp Blink

2003 Toyota Premio ZZT240

Situation
A/C lamp was blinking after a short time when the A/C switch turned on.

Cause
Faulty A/C magnet clutch

Maintenance
The panel diagnosis noticed No22 that meant locked compressor.
Then I checked the magnet clutch and measured the resistance.
The resistance should be185+-20ohm.
But it was 250ohm. Then I changed new magnet clutch.

-

Toyota Nadia SXN10 E/G Stalls

1999 Toyota Nadia SXN10 Engine Model 3S

Situation
The engine stalled at an idle.

Cause
Faulty ECU ( computer)

Maintenance
Carbon sludge were piled up by exhaust gas recirculation system.
I cleaned ECU, but it did not work well.
Then I exchaged new ECU ( computer).

Toyota Vitz SCP10 E/G Check Lamp Lit

2000 Toyota Vitz Yaris SCP10 Engine Model 1SZ

Situation
Check engine lamp illuminated.
The car run smoothly.

Cause
the nozzle of injectors clogged.

Maintenance
Diagnosis noticed P0171 that meant defect of lean vapor.
So I checked air-flow meter, spark plugs and O2 sensor.
But they were properly.
Then I took off fuel injectors and checked them.
All a third of fuel injection nozzles were clloged by carbon sludge.
After that I cleaned them and it work properly.