1997 Toyota Landcruiser HDJ81V
Situation
The automatic transmission selector lever didn't move from Park.
Cause
Disconnecting electronics ignition fuse 15A.
Maintenance
When I pressed the brake pedal, the stoplamp illuminated.
The signal of stoplamp switch was input to the No6 terminal of shift lock control relay.
The key inter lock system was properly.
Becuase of this I judged that electrical power supply and grounding wire were properly.
Then I changed a shift lock control relay , but it didn't work well.
After that I checked the voltage of the No3 terminal of the shift lock relay.
I found that there was no voltage and checked electronics ignition fuse 15A.
The fuse was disconnecting.
Then I changed the 15A fuse.
5/19/2012
5/18/2012
Toyota Sprinter AE110 SRS Lamp Lit
1998 Toyota Sprinter AE110 Engine Model 5A-FE
Situation
SRS warning lamp illuminated.
Cause
Faulty SRS control unit
Situation
SRS warning lamp illuminated.
Cause
Faulty SRS control unit
5/17/2012
Toyota Caldina ST191G E/G Not Start
1995 Toyota Caldina ST191G Engine Model 3S
Situation
The engine rotated but would not start.
Cause
Faulty ignition coil.
Maintenance
Firstly I checked electrical system and did spark test.
Spark were weak.
Then I found that there were leak at one of the ignition coil.
I changed it new ignition coil.
Situation
The engine rotated but would not start.
Cause
Faulty ignition coil.
Maintenance
Firstly I checked electrical system and did spark test.
Spark were weak.
Then I found that there were leak at one of the ignition coil.
I changed it new ignition coil.
5/15/2012
Nissan Sunny FB15 E/G Stall
2001 Nissan Sunny FB15 Engine Model QG15DE
Situation
Engine started but stoped immidiately without pressing accelrator.
Cause
Faulty Engine computer and AAC valve.
Maintenance
Diagnosis was properly.
I took off the AAC valve and checked it.
The value of resistance was out of average.(27-33ohm)
I exchanged new AAC valve. but it didn't work well.
After that I took off the engine computer
and found that platform had been burning.
Then I exchanged new engine computer.
Finaly It worked properly.
Situation
Engine started but stoped immidiately without pressing accelrator.
Cause
Faulty Engine computer and AAC valve.
Maintenance
Diagnosis was properly.
I took off the AAC valve and checked it.
The value of resistance was out of average.(27-33ohm)
I exchanged new AAC valve. but it didn't work well.
After that I took off the engine computer
and found that platform had been burning.
Then I exchanged new engine computer.
Finaly It worked properly.
5/14/2012
Toyota Mark2 GX110 Check Lamp Lit
20001 Toyota Mark2 GX110 Engine Model 1G
Situation
Engine check lamp illuminated.
The engine was hunting a liittle at an idle.
Cause
Faulty throttle position sensor.
Maintenance
Diagnosis noticed that cord P0120 which meant throttle sensor systems.
I used a service manual and confirmed by data monitor.
Then I checked throttle sensor of accelration angle and idling switch.
The throttle sensor was 0% (Faulty)
The idling switch was off (faulty)
After that I took off the throttle position sensor and checked it.
It was disconnecting at ON.(Faulty)
Then I judged that it had been faulty and exchanged new throttle position sensor.
Situation
Engine check lamp illuminated.
The engine was hunting a liittle at an idle.
Cause
Faulty throttle position sensor.
Maintenance
Diagnosis noticed that cord P0120 which meant throttle sensor systems.
I used a service manual and confirmed by data monitor.
Then I checked throttle sensor of accelration angle and idling switch.
The throttle sensor was 0% (Faulty)
The idling switch was off (faulty)
After that I took off the throttle position sensor and checked it.
It was disconnecting at ON.(Faulty)
Then I judged that it had been faulty and exchanged new throttle position sensor.
5/10/2012
Nissan Figaro FK10 Coolant Leakage
1991 Nissan Figaro FK10 Engine Model MA10
Situation
Coolant leakage in the timing belt cover.
Cause
Coolant leakage from the water pump and a bolt of the tensioner pulley.
Maintenance
I took off timing belt cover and timing belt and checked leakage from the water pump.
Then I exchaged new water pump and tested water pressure.
After that I found leakage between the timing belt and tensioner pulley.
It came from the bolt of tensioner pulley.
Then I changed a new bolt using lock sealing.
Situation
Coolant leakage in the timing belt cover.
Cause
Coolant leakage from the water pump and a bolt of the tensioner pulley.
Maintenance
I took off timing belt cover and timing belt and checked leakage from the water pump.
Then I exchaged new water pump and tested water pressure.
After that I found leakage between the timing belt and tensioner pulley.
It came from the bolt of tensioner pulley.
Then I changed a new bolt using lock sealing.
5/07/2012
Toyota Progres JCG10 VSC Lamp Lit
1999 Toyota Progres JCG10 Engine Model 1JZ
Situation
VSC warning light and TRC OFF lamp illuminated.
Cause
Faulty Steering Sensor.
Maintenance
The engine run smoothly.
When I turned the steering wheel until the end, warning lapms illuminated.
Diagnosis noticed cord31 which meant faulty of the steering sensor.
I judged that the steering sensor was faulty.
Then I exchanged new steering sensor.
After that it worked properly.
Situation
VSC warning light and TRC OFF lamp illuminated.
Cause
Faulty Steering Sensor.
Maintenance
The engine run smoothly.
When I turned the steering wheel until the end, warning lapms illuminated.
Diagnosis noticed cord31 which meant faulty of the steering sensor.
I judged that the steering sensor was faulty.
Then I exchanged new steering sensor.
After that it worked properly.
Subscribe to:
Posts (Atom)